powder instant mortar
PartoPLUG is a special instant mortar that is in dry powder form and needs only water to be consumed. This product, after mixing with water, has a very high adhesion and paste property and is used to quickly close cavities during water leakage. The initial resistance of this product is very high.
application
“PartoPLUG has a wide range of applications, including:
”
Instant termination of any water leakage
Sealing pipes and ducts
Sealing elevator shafts
Sealing pools and septic tanks
Sealing tunnels, dams and water tanks
Repair of elements with water leakage
advantages
Rapid operation of structures
Permanent control and interruption of water leakage
Can be used in direct contact with water
Fast setting and high initial resistance
No shrinkage and cracking after execution
Ease of use just by adding water to the mixture
Ability to seal and make the sections impermeable
Rapid adhesion to a variety of materials, especially concrete, brick and stone
packaging
This product is supplied in 8 kg buckets.
Typical properties
physical state powder
color grey
density ۱.۸ – ۲.۰ kg/L
* The mentioned data are obtained based on the latest controlled laboratory tests.
Standards
This product can be evaluated based on the following standards
ASTM C 928
application guidline
This product easily adheres to concrete, stone and brick and prevents water leakage.
It is best to complete the entire leak blocking operation within 20 seconds after adding water to the mixture.
It is recommended to use this product at an ambient temperature of 10 to 35 degrees Celsius and the temperature of the mixture during the run should not exceed 30 degrees.
mixing
First of all, keep in mind that after mixing water with instant powder, you have the opportunity to press the resulting paste on the leaking surface for 20 seconds. So you have to mix a small amount of instant powder and water by hand (like mixing plaster with water) and quickly press the resulting paste on the water leak for 15 seconds. It is better to start the leak filling operation from the sides of the hole and continue to the center. After blocking the leak, scrape off any excess material on the surface and level the hole with concrete or stone. In places where there is a lot of water seepage, it is better to use a pipe in the center of the hole (as a drain) and help drain the water. Finally, remove the pipe and fill the resulting hole with instantaneous.
All parts in contact with the instant must be free of any dirt, grease, dust, etc.
storage and shelf life
PartoPLUG is maintaned in closed packaging and away from direct rays of sun and ice situation.
in the case of above situation, the useful life of the product is 12 months from the date of production.
health and safety
there is not need for special actions but for observing safty actions, it is better to use protection gloves and eye glasses. In case of direct contact with skin or eyes, rinse immediately with water and see a doctor.
Please refer to the Safety Data Sheet (MSDS).
