non-acidic bonding powder

پودر بند کشی ضداسید

non-acidic bonding powder

PartoTILE-G36 is an epoxy bonding powder that consists of three components, including one component of dry powder and two components of liquid, and requires only mixing and mixing for consumption. The three components of this product, after combining with each other, have excellent mentality and, with the property of maintaining proper performance, give you the time required for fastening. This product has a high chemical resistance.


“PartoTILE-G36 is used in the installation of tiles and fasteners in vertical and horizontal surfaces that are exposed to chemical and petroleum attacks and physical pressures. Including the following: ” Dairy and food factories Plating, tanning and dyeing workshops Installation and fastening of anti-acid tiles and bricks Sealing the inlet pipes of chemical tanks Industrial kitchens, hospitals and laboratories Ceramic closure of power plant facilities and refineries Installation of stone and ceramics on the metal wall of elevators Bonding and sealing between metal to metal and metal to stone materials


Corrosion resistance Chemical resistance Available in different colors Ready to use product Achieve very high mechanical strength Very high adhesion to concrete, metal and tiles No shrinkage and cracking after execution Extreme resistance to vibration and dynamic loads Fast setting and very high resistance in the early hours


This product is supplied in three components. Component A: as a colorless liquid in a 1 kg bucket Component B: as a colorless liquid in a 0.5 kg bucket Component C: in the form of gray powder in a bag of 4,250 kg


This product can be evaluated based on the following standard: ASTM C395

Typical properties

physical state Three components A liquid, B liquid, C powder color grey density ۱.۸ kg/L Bending strength ۳۵ MPA tensile strength ۱۷ MPA compressive strength ۷۰ MPA This product is not layered and has a temperature stability of +50 ° C. * The mentioned data are obtained based on the latest controlled laboratory tests.

application guidline

۱. Never dilute the mixture. ۲. The surface moisture exposed to the binding powder should be less than 4%. ۳. Never expose the material to heat and sunlight before use. ۴. If used in cold weather, make sure that the temperature of the surfaces in contact with the bonding powder should not be less than 5 degrees Celsius. ۵. If used in hot weather, make sure that the temperature of the surfaces in contact with the bonding powder should not exceed 25 degrees Celsius. Otherwise, the performance time is greatly reduced.


All parts in contact must be free of any dirt, grease, dust, etc. ۱. Mix the two components A and B, which are in liquid form, at low speed for 20 to 30 seconds. Make sure that no trapped air bubbles remain in the mixture. ۲. Gently add component C, which is in powder form, to the liquid mixture and continue the mixing process for 2 to 3 minutes. ۳. The reaction is exothermic hardening and increasing the temperature will lead to loss of efficiency. Therefore, be careful in choosing the volume of each consumption part.

storage and shelf life

PartoTILE-G36 is maintaned in closed packaging and away from direct rays of sun and ice situation. in the case of above situation, the useful life of the product is 12 months from the date of production.

health and safety

there is not need for special actions but for observing safty actions, it is better to use protection gloves and eye glasses. In case of direct contact with skin or eyes, rinse immediately with water and see a doctor. Please refer to the Safety Data Sheet (MSDS).

اسکرول به بالا