پودر بند کشی

cement-binding powder

” PartoTILE-G16 is a cement-binding powder that is a dry powder and needs only water to be consumed. This product, after mixing with water, has excellent adhesion properties, and the resulting paste can be applied with a binding trowel, and after setting, it becomes water resistant. ”

application

“PartoTILE-G16 has a wide range of applications, including: ” “Filling all seams and joints ” Clamping all kinds of cement parts and precast concrete parts “Laying tiles, stones, ceramics and mosaics on a variety of surfaces ”

advantages

Waterproof “Easy and fast mixing ” Ease and speed in execution Resistant to moisture No shrinkage Resistant to environmental factors Applicable in vertical and horizontal planes Resistant to tensile and compressive stresses “Water resistant and frost resistant ”

packaging

This product is supplied in 5 kg bags.

Typical properties

phusical state powder color based on order density 1.7 kg/L PH Alkaline * The mentioned data are obtained based on the latest controlled laboratory tests.

technical information

This product can be evaluated by BS EN 13888 and ISIRI 12495-4 standards.

application guidline

Fastening can be done with a rubber spatula. After adding water to the mixture, it is best to complete the whole closing operation within 60 minutes. It is recommended to run this product at an ambient temperature of 5 to 35 degrees Celsius and the temperature of the mixture during the run should not exceed 30 degrees. “To seal the horizontal sections (floor), mix the sealing powder with more water so that it can be easily applied at the joints. ” Before laying the tile, wet the tile with a sponge and clean it, and when smoothing the laying mortar, wet the laying trowel with a sponge or a damp cloth.

mixing

First, pour 1.5 liters of water into the blender container and then gently pour the 5 kg bag into the water. Turn on the mixer and continue the mixing process at low speed (less than 500 rpm) for 3 minutes. Leave the prepared tile adhesive mortar for 1 minute. Repeat the mixing operation for a short time and then perform the tightening operation with a rubber spatula. It is recommended to keep the applied surface moist for up to 24 hours after finishing the bonding. All parts in contact with the adhesive should be free of any dirt, grease, dust, etc. and it is better to moisten it with a little water.

storage and shelf life

PartoTILE-G16 is maintaned in closed packaging and away from direct rays of sun and ice situation. in the case of above situation, the useful life of the product is 12 months from the date of production.

health and safety

there is not need for special actions but for observing safty actions, it is better to use protection gloves and eye glasses. In case of direct contact with skin or eyes, rinse immediately with water and see a doctor. Please refer to the Safety Data Sheet (MSDS).

Scroll to Top